Panasonic 17" & 8.4" Monitors
CINEYE 5G WI-FI
VARIOUS MONITOR AND
SmallHD Hi-Brite 17" Monitor
SmallHD 702 Bright 7" Monitor
SmallHD 502 5" Monitor with Sidefinder
GPS has three Panasonic BT-LH1760 17" flat-screen HD monitors that have two SDI inputs so you can switch between the two. Also features a waveform monitor and vectorscope, pixel to pixel display, cross-hatch, and can display timecode and audio signals. Can be table mounted or mounted on a stand. Battery powered or run off power.
GPS has two Panasonic BT-LH900A 8.4" HD portable monitors that feature a waveform and vectorscope and come in a Petrol case with a built-in hood. The monitors weigh 4.4 lbs. and have a slim 2.5" profile, Runs off gold-mount batteries or a 4-pin power source, is very portable and can be mounted on a stand.
The SmallHD 1703 17" monitor is built extremely tough and features waveform and vectorscope, histogram, false-color, and split-screen allowing viewing of two live video feeds. This Hi-Brite monitor accepts both HDMI and SDI inputs and can be viewed in direct sunlight without needing a sunshade. It can be powered from ac power or a gold-mount battery.
The SmallHD 702 Bright 7" on-camera monitor is not only daylight viewable without a sunshade but also has a full HD 1080p display and a 1000:1 contrast ratio. The 7" monitor accepts HD-SDI and HDMI inputs and can be powered off ac power, Sony L-series or Canon LP-E6 batteries or the camera's d-tap. Comes with various rigs to move to your camera.
IN VARIOUS LENGTHS
The SmallHD 502 5" monitor accepts both HDMI and SDI inputs and outputs and provides signal cross-conversion. The unit is 3/4" thick and weighs 9 ounces [not including batteries] so it is light enough to rig on a camera without weighing you down. The monitor supports 3D LUTs which you can save to a page that can be then applied to
the monitor's screen, the output, or both at the same time. The 502 Sidefinder is an optical loupe that attaches to the 502 monitor to create a flexible, hi-rez EVF viewfinder that works with any camera outputting an HDMI or SDI signal.
Teradek Bolt 500 XT Wireless Systems
GPS offers two Teradek Bolt 500 XT 3G-SDI/HDMI Wireless systems which provide 500 ft. line-of-site zero latency wireless video transmission. The receiver accepts SDI or HDMI signals and can cross convert the signal to send either an SDI or HDMI signal to up to four monitors, We also offer dual 14.4-volt gold mount battery plates for easy rigging and power for the transmitters.
Decimator Dmon 6S 6 Channel Multi-Viewer
The Decimator Dmon 6S 6 Channel Multi-viewer with HDMI and SDI outputs allows you to accept up to six independent SDI video signals and split them out via SDI or HDMI to a single monitor.
SmallHD Focus 5" On-Camera HDMI Monitor with 180 degree tilt-arm. This monitor is viewable in daylight without a sunhood, mounts in the camera's hotshoe mount, and features a touchscreen with waveform, false-color, and vectorscope. Perfect for DSLR and mirrorless cameras.